| // Copyright lowRISC contributors. | |
| // Licensed under the Apache License, Version 2.0, see LICENSE for details. | |
| // SPDX-License-Identifier: Apache-2.0 | |
| #include "sw/device/boot_rom/bootstrap.h" | |
| #include "sw/device/boot_rom/chip_info.h" // Generated. | |
| #include "sw/device/lib/arch/device.h" | |
| #include "sw/device/lib/base/mmio.h" | |
| #include "sw/device/lib/dif/dif_gpio.h" | |
| #include "sw/device/lib/dif/dif_uart.h" | |
| #include "sw/device/lib/pinmux.h" | |
| #include "sw/device/lib/runtime/hart.h" | |
| #include "sw/device/lib/runtime/log.h" | |
| #include "sw/device/lib/runtime/print.h" | |
| #include "sw/device/lib/testing/check.h" | |
| #include "sw/device/lib/testing/test_status.h" | |
| #include "hw/top_earlgrey/sw/autogen/top_earlgrey.h" // Generated. | |
| /** | |
| * This symbol is defined in sw/device/boot_rom/rom_link.ld, | |
| * and describes the location of the flash header. | |
| * | |
| * The actual contents are not defined by the ROM, but rather | |
| * by the flash binary: see sw/device/exts/common/flash_link.ld | |
| * for that. | |
| */ | |
| extern struct { void (*entry)(void); } _flash_header; | |
| static dif_uart_t uart0; | |
| void _boot_start(void) { | |
| test_status_set(kTestStatusInBootRom); | |
| pinmux_init(); | |
| CHECK(dif_uart_init( | |
| (dif_uart_params_t){ | |
| .base_addr = mmio_region_from_addr(TOP_EARLGREY_UART_BASE_ADDR), | |
| }, | |
| &uart0) == kDifUartOk, | |
| "failed to init UART"); | |
| CHECK(dif_uart_configure(&uart0, | |
| (dif_uart_config_t){ | |
| .baudrate = kUartBaudrate, | |
| .clk_freq_hz = kClockFreqPeripheralHz, | |
| .parity_enable = kDifUartToggleDisabled, | |
| .parity = kDifUartParityEven, | |
| }) == kDifUartConfigOk, | |
| "failed to configure UART"); | |
| base_uart_stdout(&uart0); | |
| LOG_INFO("%s", chip_info); | |
| int bootstrap_err = bootstrap(); | |
| if (bootstrap_err != 0) { | |
| LOG_ERROR("Bootstrap failed with status code: %d", bootstrap_err); | |
| // Currently the only way to recover is by a hard reset. | |
| test_status_set(kTestStatusFailed); | |
| } | |
| LOG_INFO("Boot ROM initialisation has completed, jump into flash!"); | |
| // Jump into flash. At this point, the contents of the flash binary have been | |
| // verified, and we can transfer control directly to it. It is the | |
| // flash binary's responsibily to set up its own stack, and to never | |
| // return. | |
| _flash_header.entry(); | |
| // If the flash image returns, we should abort anyway. | |
| abort(); | |
| } |