hw/ip/gpio/data/gpio.hjson

// Copyright lowRISC contributors.
// Licensed under the Apache License, Version 2.0, see LICENSE for details.
// SPDX-License-Identifier: Apache-2.0
{
  name: "gpio",
  clock_primary: "clk_i",
  bus_interfaces: [
    { protocol: "tlul", direction: "device" }
  ],
  available_inout_list: [
    { name: "gpio",
      width: 32,
      desc: "GPIO inout to/from PAD"
    }
  ],
  interrupt_list: [
    { name: "gpio",
      width: 32,
      desc: "raised if any of GPIO pin detects configured interrupt mode"
    }
  ],

  regwidth: "32",
  registers: [
    { name: "DATA_IN",
      desc: "GPIO Input data read value",
      swaccess: "ro",
      hwaccess: "hwo",
      tags: [// data_in is ro register, so exclude its readback check
             "excl:CsrNonInitTests:CsrExclWriteCheck"],
      fields: [
        { bits: "31:0",
          resval: "x"
        }
      ],
    },
    { name: "DIRECT_OUT",
      desc: "GPIO direct output data write value",
      swaccess: "rw",
      hwaccess: "hrw",
      hwext: "true",
      hwqe: "true",
      fields: [
        { bits: "31:0" }
      ],
    },
    { name: "MASKED_OUT_LOWER",
      desc: '''GPIO write data lower with mask.

            Masked write for DATA_OUT[15:0].

            Upper 16 bits of this register are used as mask. Writing
            lower 16 bits of the register changes DATA_OUT[15:0] value
            if mask bits are set.

            Read-back of this register returns upper 16 bits as zero
            and lower 16 bits as DATA_OUT[15:0].
            '''
      swaccess: "rw",
      hwaccess: "hrw",
      hwext: "true",
      hwqe: "true",
      tags: [// read value of masked_* registers yield a different value than written
             // avoid writing to masked_out* registers as they affect direct_out value
             "excl:CsrNonInitTests:CsrExclAll"],
      fields: [
        { bits: "15:0",
          name: "data",
          desc: '''Write data value[15:0].

                Value to write into DATA_OUT[i], valid in the presence of mask[i]==1
                '''
        },
        { bits: "31:16",
          name: "mask",
          desc: '''Write data mask[15:0].

                A value of 1 in mask[i] allows the updating of DATA_OUT[i], 0 <= i <= 15
                '''
          swaccess: "wo"
        },
      ],
    },
    { name: "MASKED_OUT_UPPER",
      desc: '''GPIO write data upper with mask.

            Masked write for DATA_OUT[31:16].

            Upper 16 bits of this register are used as mask. Writing
            lower 16 bits of the register changes DATA_OUT[31:16] value
            if mask bits are set.

            Read-back of this register returns upper 16 bits as zero
            and lower 16 bits as DATA_OUT[31:16].
            '''
      swaccess: "rw",
      hwaccess: "hrw",
      hwext: "true",
      hwqe: "true",
      tags: [// read value of masked_* registers yield a different value than written
             // avoid writing to masked_out* registers as they affect direct_out value
             "excl:CsrNonInitTests:CsrExclAll"],
      fields: [
        { bits: "15:0",
          name: "data",
          desc: '''Write data value[31:16].

                   Value to write into DATA_OUT[i], valid in the presence of mask[i]==1
                '''
        },
        { bits: "31:16",
          name: "mask",
          desc: '''Write data mask[31:16].

                A value of 1 in mask[i] allows the updating of DATA_OUT[i], 16 <= i <= 31
                '''
          swaccess: "wo"
        },
      ],
    },
    { name: "DIRECT_OE",
      desc: '''GPIO Output Enable.

            Setting direct_oe[i] to 1 enables output mode for GPIO[i]
            ''',
      swaccess: "rw",
      hwaccess: "hrw",
      hwext: "true",
      hwqe: "true",
      fields: [
        { bits: "31:0" }
      ],
    },
    { name: "MASKED_OE_LOWER",
      desc: '''GPIO write Output Enable lower with mask.

            Masked write for DATA_OE[15:0], the register that controls
            output mode for GPIO pins [15:0].

            Upper 16 bits of this register are used as mask. Writing
            lower 16 bits of the register changes DATA_OE[15:0] value
            if mask bits are set.

            Read-back of this register returns upper 16 bits as zero
            and lower 16 bits as DATA_OE[15:0].
            ''',
      swaccess: "rw",
      hwaccess: "hrw",
      hwext: "true",
      hwqe: "true",
      tags: [// read value of masked_* registers yield a different value than written
             // avoid writing to masked_oe* registers as they affect direct_oe value
             "excl:CsrNonInitTests:CsrExclAll"],
      fields: [
        { bits: "15:0",
          name: "data",
          desc: '''Write OE value[15:0].

                Value to write into DATA_OE[i], valid in the presence of mask[i]==1
                ''',
        },
        { name: "mask",
          desc: '''Write OE mask[15:0].

                A value of 1 in mask[i] allows the updating of DATA_OE[i], 0 <= i <= 15
                ''',
          bits: "31:16"
        },
      ],
    },
    { name: "MASKED_OE_UPPER",
      desc: '''GPIO write Output Enable upper with mask.

            Masked write for DATA_OE[31:16], the register that controls
            output mode for GPIO pins [31:16].

            Upper 16 bits of this register are used as mask. Writing
            lower 16 bits of the register changes DATA_OE[31:16] value
            if mask bits are set.

            Read-back of this register returns upper 16 bits as zero
            and lower 16 bits as DATA_OE[31:16].
            ''',
      swaccess: "rw",
      hwaccess: "hrw",
      hwext: "true",
      hwqe: "true",
      tags: [// read value of masked_* registers yield a different value than written
             // avoid writing to masked_oe* registers as they affect direct_oe value
             "excl:CsrNonInitTests:CsrExclAll"],
      fields: [
        { bits: "15:0",
          name: "data",
          desc: '''Write OE value[31:16].

                Value to write into DATA_OE[i], valid in the presence of mask[i]==1
                ''',
        },
        { name: "mask",
          desc: '''Write OE mask[31:16].

                A value of 1 in mask[i] allows the updating of DATA_OE[i], 16 <= i <= 31
                ''',
          bits: "31:16"
        },
      ],
    },

    { name: "INTR_CTRL_EN_RISING",
      desc: '''GPIO interrupt enable for GPIO, rising edge.

            If !!INTR_ENABLE[i] is true, a value of 1 on !!INTR_CTRL_EN_RISING[i]
            enables rising-edge interrupt detection on GPIO[i].
            ''',
      swaccess: "rw",
      hwaccess: "hro",
      fields: [
        { bits: "31:0" }
      ],
    },
    { name: "INTR_CTRL_EN_FALLING",
      desc: '''GPIO interrupt enable for GPIO, falling edge.

            If !!INTR_ENABLE[i] is true, a value of 1 on !!INTR_CTRL_EN_FALLING[i]
            enables falling-edge interrupt detection on GPIO[i].
            ''',
      swaccess: "rw",
      hwaccess: "hro",
      fields: [
        { bits: "31:0" }
      ],
    },
    { name: "INTR_CTRL_EN_LVLHIGH",
      desc: '''GPIO interrupt enable for GPIO, level high.

            If !!INTR_ENABLE[i] is true, a value of 1 on !!INTR_CTRL_EN_LVLHIGH[i]
            enables level high interrupt detection on GPIO[i].
            ''',
      swaccess: "rw",
      hwaccess: "hro",
      fields: [
        { bits: "31:0" }
      ],
    },
    { name: "INTR_CTRL_EN_LVLLOW",
      desc: '''GPIO interrupt enable for GPIO, level low.

            If !!INTR_ENABLE[i] is true, a value of 1 on !!INTR_CTRL_EN_LVLLOW[i]
            enables level low interrupt detection on GPIO[i].
            ''',
      swaccess: "rw",
      hwaccess: "hro",
      fields: [
        { bits: "31:0" }
      ],
    },
    { name: "CTRL_EN_INPUT_FILTER",
      desc: '''filter enable for GPIO input bits.

            If !!CTRL_EN_INPUT_FILTER[i] is true, a value of input bit [i]
            must be stable for 16 cycles before transitioning.
            ''',
      swaccess: "rw",
      hwaccess: "hro",
      fields: [
        { bits: "31:0" }
      ],
    },
  ],
}