[padctrl/fpv/lint] Fix inout wire issue with lint and fpv
diff --git a/hw/ip/padctrl/rtl/padring.sv b/hw/ip/padctrl/rtl/padring.sv
index 77290ce..979fc94 100644
--- a/hw/ip/padctrl/rtl/padring.sv
+++ b/hw/ip/padctrl/rtl/padring.sv
@@ -37,11 +37,20 @@
// Infrastructure
//////////////////////////////////////////////////////
+ // use this intermediate assignment to make both lint and fpv happy.
+ // the clock/reset wires should be input-only, otherwise fpv
+ // has trouble defining/tracing the clock signal. on the other hand, a direct
+ // connection of input wire to an inout pad causes lint problems
+ // (even though oe is hardwired to 0).
+ wire clk, rst_n;
+ assign clk = clk_i;
+ assign rst_n = rst_ni;
+
prim_pad_wrapper #(
.Impl(Impl),
.AttrDw(padctrl_reg_pkg::AttrDw)
) i_clk_pad (
- .inout_io ( clk_i ),
+ .inout_io ( clk ),
.in_o ( clk_o ),
.out_i ( 1'b0 ),
.oe_i ( 1'b0 ),
@@ -52,7 +61,7 @@
.Impl(Impl),
.AttrDw(padctrl_reg_pkg::AttrDw)
) i_rst_pad (
- .inout_io ( rst_ni ),
+ .inout_io ( rst_n ),
.in_o ( rst_no ),
.out_i ( 1'b0 ),
.oe_i ( 1'b0 ),
