diff --git a/CreateSpringbokVectorUnitTest.md b/CreateSpringbokVectorUnitTest.md
index 3b3f4da..74dccf6 100644
--- a/CreateSpringbokVectorUnitTest.md
+++ b/CreateSpringbokVectorUnitTest.md
@@ -170,7 +170,7 @@
 From the root directory, run `sim_springbok`
 
 ```sh
-sim_springbok ./out/springbok/tests/vadd_test.elf
+sim_springbok ./out/springbok/rvv/tests/vadd_test.elf
 ```
 
 This will run the single elf, and if there is an error, can give useful
@@ -181,7 +181,7 @@
 From the root directory, run `qemu_sim_springbok`
 
 ```sh
-qemu_sim_springbok ./out/springbok/tests/vadd_test.elf
+qemu_sim_springbok ./out/springbok/rvv/tests/vadd_test.elf
 ```
 
 ## Step 6.2 (Optional): Debug Elf with Renode/Qemu and gdb
@@ -191,24 +191,24 @@
 
 Start Renode simulation:
 ```sh
-sim_springbok ./out/springbok/tests/vadd_test.elf debug
+sim_springbok ./out/springbok/rvv/tests/vadd_test.elf debug
 ```
 Alternatively, start Qemu simulation:
 
 ```sh
-qemu_sim_springbok ./out/springbok/tests/vadd_test.elf -s -S
+qemu_sim_springbok ./out/springbok/rvv/tests/vadd_test.elf -s -S
 ```
 
 Now, in the other console session run the following command to start a gdb session:
 
 ```sh
-cache/toolchain/bin/riscv32-unknown-elf-gdb -ex "target remote :3333" out/springbok/tests/vadd_test.elf
+cache/toolchain/bin/riscv32-unknown-elf-gdb -ex "target remote :3333" out/springbok/rvv/tests/vadd_test.elf
 ```
 
 Note: To run GDB with the Qemu simulation, use
 
 ```sh
-cache/toolchain/bin/riscv32-unknown-elf-gdb -ex "target remote :1234" out/springbok/tests/vadd_test.elf
+cache/toolchain/bin/riscv32-unknown-elf-gdb -ex "target remote :1234" out/springbok/rvv/tests/vadd_test.elf
 ```
 
 First, in the Renode session, type `start`.
@@ -231,7 +231,7 @@
 
 Run this on the elf (while in the `$ROOTDIR`):
 ```sh
-cache/toolchain_iree_rv32imf/bin/riscv32-unknown-elf-objdump -d out/springbok/tests/vadd_test.elf | less
+cache/toolchain_iree_rv32imf/bin/riscv32-unknown-elf-objdump -d out/springbok/rvv/tests/vadd_test.elf | less
 ```
 
 Then search for the PC for any instruction of interest.
@@ -254,7 +254,7 @@
 Code for the main test was autogenerated, however by `cd`'ing into the following directory, one can inspect the generated code.
 
 ```sh
-${ROOTDIR}/out/springbok/tests/generated/
+${ROOTDIR}/out/springbok/rvv/tests/generated/
 ```
 
 ## Step 9: Mark Tests as Passing