sencha: add simulate+cli target

This adds a version of the `simulate` target that also enables the
simulator command line interface on port 4567. To access the simulator
use something like telnet localhost 4567. Note renode will block until
the cli is connected.

Change-Id: Ibaf28e911f0a9254bf55dbf1283e9dbce7b6bfca

platforms/sencha/sim.mk

diff --git a/platforms/sencha/sim.mk b/platforms/sencha/sim.mk
index 5ff05ee..42ce255 100644
--- a/platforms/sencha/sim.mk
+++ b/platforms/sencha/sim.mk
@@ -77,6 +77,18 @@
     $(PORT_PRESTART_CMDS) i @${SENCHA_RESC_RELEASE}; \
         $(RENODE_PRESTART_CMDS) start"
 
+## Version of the `simulate` target that also enables the simulator command
+## line interface on port 4567. To access the simulator use something like
+## telnet localhost 4567. Note renode will block until the cli is connected.
+simulate+cli: renode cheriot_sim kelvin_sim multihart_boot_rom ext_flash_release
+	$(RENODE_CMD) -e "\
+    \$$repl_file = @${SENCHA_REPL}; \
+    \$$tar = @$(EXT_FLASH_RELEASE); \
+    \$$sc_bin =@$(TMP_RELEASE)/matcha-tock-bundle.bin; \
+    \$$cli_port = 4567; \
+    $(PORT_PRESTART_CMDS) i @${SENCHA_RESC_RELEASE}; \
+        $(RENODE_PRESTART_CMDS) start"
+
 ## Debug version of the `simulate` target
 #
 # This top-level target does the same job as `simulate`, but instead of