| <!-- |
| Copyright 2019, Data61, CSIRO (ABN 41 687 119 230) |
| |
| SPDX-License-Identifier: CC-BY-SA-4.0 |
| --> |
| |
| # PicoServer |
| |
| This is a sample application which uses the PicoServer component as well as the |
| Ethdriver component to demonstrate networking on CAmkES. There are two |
| components, Echo and Listener. Echo will listen on a particular port (in this |
| case, 1234) and forward any messages to Listener. Listener will then print the |
| message out via the serial port. |
| |
| Usage: |
| netcat <IP address> 1234 |
| |
| Config |
| ------ |
| |
| There are some configuration options that may need to be changed. The |
| configuration options lie inside the picoserver.camkes file. |
| |
| These include: |
| - IP address to assign to the PicoServer component, see picoserver.ip_addr, |
| and the CMake variable PICOSERVER_IP_ADDR |
| - MAC address of the device, see picoserver.ethdriver_mac |
| - If on x86, the hardware details of Ethernet device, which includes: |
| * Physical address of the base of the memory-mapped device |
| * Size of the memory region |
| * IRQ-related information (PCI, MSI, etc) |
| * IO spaces and ID of the device |
| * PCI bus/dev/function information of the device |
| - If on ARM, the Ethdriver component supports two boards at this time of |
| writing (24/04/19), the IMX6 and the ZYNQ7000. Promiscuous mode can be |
| turned on by setting ethdriver.promiscuous_mode to 1, otherwise off if |
| set to 0. Look at the Ethdriver component inside the global-components |
| repository, and libethdrivers inside the util_libs repository for adding |
| support to another board. |
