{
  name: "GP",
  clock_primary: "clk_fixed",
  bus_device: "tlul",

  regwidth: "32",
  registers: [
    { name: "OE",
      desc: '''GPIO Output Enable

            bit[i]=1'b0: Input mode for GPIO[i]
            bit[i]=1'b1: Output mode for GPIO[i]
            ''',
      swaccess: "rw",
      fields: [
        { bits: "31:0" }
      ],
    },
    { reserved: "4" }
    { name: "DATA_IN",
      desc: "GPIO Input data read bitfield",
      swaccess: "ro",
      fields: [
        { bits: "31:0",
          resval: "x"
        }
      ],
    },
    # multireg for single bit instance?
    { multireg: {
        name: "DATA_OUT",
        desc: "GPIO output data",
        count: "32",
        cname: "GPIO",
        swaccess: "rw",
        fields: [
          { bits: "0", name: "D" desc: "Output data" }
        ],
      }
    },

    { multireg: {
          name: "INT_CTRL",
	  desc: "GPIO Interrupt control",
	  count: "32",
	  cname: "GPIO",
	  swaccess: "rw",
	  fields: [
	      { bits: "0", name: "POS", resval: "0",
	        desc: "Set to interrupt on rising edge"
	      }
	      { bits: "1", name: "NEG", resval: "0",
	        desc: "Set to interrupt on falling edge"
	      }
	      { bits: "4:2", name: "TYPE", resval: "0",
	        desc: "Type of interrupt to raise"
		enum: [
		  {value: "0", name: "none", desc: "log but no interrupt" },
		  {value: "1", name: "low", desc: "low priotiry interrupt" },
		  {value: "2", name: "high", desc: "high priotiry interrupt" },
		  {value: "3", name: "nmi", desc: "non maskable interrupt" }
		]
	      }
	  ]
      }
    },
    { multireg: {
          name: "WDATA",
	  desc: "Write with mask to GPIO out register",
	  count: "32",
	  cname: "GPIO",
	  swaccess: "rw",
	  fields: [
	      { bits: "0", name: "DATA", resval: "0",
	        desc: "Data to write if mask bit is 1"
	      }
	      { bits: "16", name: "MASK", resval: "0",
	        desc: "Set to allow data write"
	      }
	  ]
      }
    }
  ]
}