// Copyright lowRISC contributors.
// Licensed under the Apache License, Version 2.0, see LICENSE for details.
// SPDX-License-Identifier: Apache-2.0
{ name: "otbn"
  clock_primary: "clk_i"
  other_clock_list: [
    "clk_edn_i"
  ],
  reset_primary: "rst_ni",
  other_reset_list: [
    "rst_edn_ni"
  ]
  bus_interfaces: [
    { protocol: "tlul", direction: "device" }
  ],
  param_list: [
    { name:    "RegFile",
      type:    "otbn_pkg::regfile_e",
      default: "otbn_pkg::RegFileFF",
      desc:    "Selection of the register file implementation. See otbn_pkg.sv."
      local:   "false",
      expose:  "true"
    },
    { name:    "RndCnstUrndLfsrSeed",
      type:    "otbn_pkg::urnd_lfsr_seed_t",
      desc:    '''
        Default seed of the PRNG used for URND.
      '''
      randcount: "256",
      randtype:  "data"
    },
    { name:    "RndCnstUrndChunkLfsrPerm",
      type:    "otbn_pkg::urnd_chunk_lfsr_perm_t",
      desc:    '''
        Permutation applied to the LFSR chunks of the PRNG used for URND.
      '''
      randcount: "64",
      randtype:  "perm"
    },
  ]
  interrupt_list: [
    { name: "done"
      desc: "OTBN has completed the operation"
    }
  ]
  alert_list: [
    { name: "fatal"
      desc: "A fatal error. Fatal alerts are non-recoverable and will be asserted until a hard reset."
    }
    { name: "recov"
      desc: "A recoverable error. Just sent once (as the processor stops)."
    }
  ]

  inter_signal_list: [
    // EDN interface for RND
    { struct:  "edn"
      type:    "req_rsp"
      name:    "edn_rnd"
      act:     "req"
      package: "edn_pkg"
    },

    // EDN interface for URND
    { struct:  "edn"
      type:    "req_rsp"
      name:    "edn_urnd"
      act:     "req"
      package: "edn_pkg"
    },

    // OTBN is not performing any operation and can be clock/power-gated.
    { name:    "idle",
      type:    "uni",
      struct:  "logic",
      width:   "1",
      act:     "req",
    },

    // ram configuration
    { struct:  "ram_1p_cfg",
      package: "prim_ram_1p_pkg",
      type:    "uni",
      name:    "ram_cfg",
      act:     "rcv"
    }
  ],

  regwidth: "32"
  registers: [
    { name: "CMD"
      desc: "command register",
      swaccess: "r0w1c",
      hwaccess: "hro",
      hwext: "true",
      hwqe:  "true",
      fields: [
        { bits: "0"
          name: "start"
          desc: '''
            Start the operation

            The completion is signalled by the done interrupt.
          '''
          tags: [
            // Don't write this field in the automated CSR tests. Doing so will
            // start OTBN, but we won't have initialised its memory with any
            // code, so we'll get Xs on its interfaces and everything will be
            // a bit of a mess!
            "excl:CsrAllTests:CsrExclWrite"
          ]
        }
      ],
    }
    { name: "STATUS",
      desc: "Status",
      swaccess: "ro",
      hwaccess: "hwo",
      hwext: "true",
      fields: [
        { bits: "0",
          name: "busy",
          desc: "OTBN is performing an operation."
        }
      ]
    } // register : status
    { name: "ERR_BITS",
      desc: '''
        Error bitfield. Reads as non-zero if an error was seen during OTBN
        operation
      ''',
      swaccess: "ro",
      hwaccess: "hwo",
      fields: [
        { bits: "0",
          name: "bad_data_addr"
          desc: '''
            A DMEM read or write occurred with an out of bounds or unaligned
            address.
          '''
        }
        { bits: "1",
          name: "bad_insn_addr"
          desc: '''
            An IMEM read occurred with an out of bounds or unaligned address.
          '''
        }
        { bits: "2",
          name: "call_stack"
          desc: '''
            A instruction tried to pop from an empty call stack or push to a
            full call stack.
          '''
        }
        { bits: "3",
          name: "illegal_insn"
          desc: '''
            One of the following happened:
            <ul>
              <li>An instruction being excuted had an invalid encoding.</li>
              <li>An access occurred for an invalid CSR or WSR.</li>
              <li>
                A CSR or WSR access occurred that is not permitted (e.g. writing
                to a read-only CSR or WSR).
              </li>
            </ul>
          '''
        }
        { bits: "4",
          name: "loop"
          desc: '''
            One of the following happened:
            <ul>
              <li>A loop was started with an iteration count of zero.</li>
              <li>
                The final instruction of a loop was a branch or another loop.
              </li>
              <li>
                A new loop tried to push to a full loop stack (loop nesting
                level too deep).
              </li>
            </ul>
          '''
        }
        { bits: "5",
          name: "fatal_imem"
          desc: "A fatal failure was seen on an instruction fetch."
        }
        { bits: "6",
          name: "fatal_dmem"
          desc: "A fatal failure was seen on a DMEM read."
        }
        { bits: "7",
          name: "fatal_reg"
          desc: "A fatal failure was seen on a GPR or WDR read."
        }
      ]
    } // register : err_bits
    { name: "START_ADDR",
      desc: "Start byte address in the instruction memory",
      swaccess: "wo",
      hwaccess: "hro",
      fields: [
        { bits: "31:0",
          name: "start_addr",
          resval: 0,
          desc: '''
            Byte address in the instruction memory OTBN starts to execute from
            when instructed to do so with the !!CMD.start .
          '''
        }
      ]
    } // register : start_addr
    { name: "FATAL_ALERT_CAUSE",
      desc: '''
        The cause of a fatal alert.

        The bits of this register correspond to errors that can cause a fatal
        alert. Software can read these bits to see what went wrong. Once set,
        these bits cannot be cleared.
      '''
      swaccess: "ro",
      hwaccess: "hwo",
      fields: [
        { bits: "0",
          name: "bus_integrity_error",
          resval: 0,
          desc: '''
            Set by a failed integrity check on a bus access.
            Note that this can happen even when OTBN is not running.
          '''
        }
        { bits: "1",
          name: "imem_error",
          resval: 0,
          desc: "Set on any ECC error in IMEM"
        }
        { bits: "2",
          name: "dmem_error",
          resval: 0,
          desc: "Set on any ECC error in DMEM"
        }
        { bits: "3",
          name: "reg_error",
          resval: 0,
          desc: "Set on any ECC error in a register file"
        }
      ]
    }

    // Give IMEM and DMEM 16 KiB address space, each, to allow for easy expansion
    // of the actual IMEM and DMEM sizes without changing the address map.
    { skipto: "0x4000" }

    // Imem size (given as `items` below) must be a power of two.
    { window: {
        name: "IMEM",
        items: "1024", // 4 kB
        swaccess: "rw",
        data-intg-passthru: "true",
        byte-write: "false",
        desc: '''
          Instruction Memory.

          This register should only be accesed while OTBN is not busy, as indicated by the !!STATUS.busy flag.
          Accesses while OTBN is busy are blocking.

          TODO: The exact behavior is yet to be determined, see https://github.com/lowRISC/opentitan/issues/2696 for details.
        '''
      }
    }

    { skipto: "0x8000" }

    // Dmem size (given as `items` below) must be a power of two.
    { window: {
        name: "DMEM",
        items: "1024", // 4 kB
        swaccess: "rw",
        data-intg-passthru: "true",
        byte-write: "false",
        desc: '''
          Data Memory.

          This register should only be accesed while OTBN is not busy, as indicated by the !!STATUS.busy flag.
          Accesses while OTBN is busy are blocking.

          TODO: The exact behavior is yet to be determined, see https://github.com/lowRISC/opentitan/issues/2696 for details.
        '''
      }
    }
  ]
}